Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 554 (POWER STEERING)REMOVAL AND INSTALLATIONSTEERING GEAR BOOTREMOVAL
2021 Ford Edge SE, 4WD
Steering Gear Boot: Removal
2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the tie rod end. Refer to: Tie Rod End .
-
NOTE: Count and record the number of turns required to remove the outer tie-rod end jamb nut for reference during installation.
Remove the tie-rod end jamb nut.
- Remove the front engine undershield. Refer to: Engine Front Undershield .
-
- Remove and discard the outer steering gear boot clamp.
- Remove and discard the inner steering gear boot clamp.
-
NOTE: If servicing the RH (right-hand) tie rod, both bellows boots must be removed.
Remove the bellows boot.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.