Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
About This Service Information: Introduction
For additional information, refer to: Health and Safety Precautions .
This service information describes and directs repair procedures specified by Ford Motor Company for the vehicle. Critical health and safety precautions are included. Anyone who deviates from these instructions risks compromising personal safety or vehicle integrity.
CONTENT
This service information is divided into groups, each containing sections numbered based on the component part number. Contents may include:
- Specifications
- Fluid capacities, component specifications and torque values not covered in other procedures
- Description and Operation
- Overview of the system, component locations, and system operation
- Diagnosis and Testing
- Symptom charts, DTC charts and diagnostic tests
- See the Diagnosis and Testing Information in this document
- General Procedures
- Service adjustments, electronic programming and other special procedures
- Removal and Installation
- Component removal and installation instructions
- Removal
- Component removal instructions
- Installation
- Component installation instructions
- Disassembly and Assembly
- Component disassembly and assembly instructions
- Disassembly and Assembly of Subassemblies
- Assembly disassembly and assembly instructions
IMPORTANT INFORMATION
This Service Information contains the following important information:
- Critical Health and Safety Precautions - service safety precautions applicable to the entire manual. For additional information, refer to: Health and Safety Precautions .
- A Symbols Glossary - definitions of the action directed by each symbol. For additional information, refer to: Symbols Glossary .
- Diagnostic Methods - support information for diagnostics. For additional information, refer to: Diagnostic Methods .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.