Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connector End View (C4002) - INLINE
| Inline: | Description | Color | Harness | Base Part # | Service Pigtail | |||
|---|---|---|---|---|---|---|---|---|
| C4002 | INLINE | GY | 14B56214405 | See Below | ||||
MALE
Harness
14B562
FEMALE
Harness
14405
| Terminal Part Number | Service Part Number | Size |
|---|---|---|
| 7C3T-14474-SA | LU2Z-14474-CA | 1.50 |
| 7C3T-14474-RA | LU2Z-14474-CA | 1.50 |
| AU5T-14421-BA | Not Available |
| Pin | Circuit | Gauge | Qualifier | Terminal Part Number | ||
| 1 | CBBD8 (GY-OG) | 18 | AU5T-14421-BA | |||
| 2 | CPL10 (BK) | 18 | AU5T-14421-BA | |||
| Pin | Circuit | Gauge | Qualifier | Terminal Part Number | ||
| 1 | CBBD8 (GY-OG) | 16 | 7C3T-14474-SA|7C3T-14474-RA | |||
| 1 | CBBD8 (GY-OG) | 20 | 7C3T-14474-SA|7C3T-14474-RA | |||
| 2 | CPL10 (BK) | 18 | 7C3T-14474-SA | |||
Available Pigtail Kits
Pigtail Kit Part Number WPT-1618
Service Part Number:
KU2Z-14S411-LA
Gauge:
16
Pin material:
Silver
Cavities:
2
Vehicle Uses:
- Antenna - Keyless Entry
- Connector - Inline
- Switch - Seat Belt Warning
Pigtail Kit Part Number WPT-1116
Service Part Number:
AU2Z-14S411-BJA
Gauge:
16
Pin material:
Silver
Cavities:
2
Vehicle Uses:
- Lamp - Running Board
- Sensor - Knock
- Sensor - Speed
- Sensor - Water in Fuel
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.