Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connector End View (C1273B) - GLOW PLUG CONTROL MODULE (GPCM)
2021 Ford Edge SE, 4WDSECTION Connector End View (C1273B) - GLOW PLUG CONTROL MODULE (GPCM)
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Color
BK
Harness
12A581
Base Part #
part# N/A
Service Pigtail
See Below
Check for Terminal Part Numbers
| Pin | Circuit | Gauge | Circuit Function | Qualifier |
| 1 | CE243 (GY-VT) | 4 | CTRL MOD. - GLOW PLUG 1 OR ELECTRONIC COLD START | |
| 2 | CE244 (BU-BN) | 4 | CTRL MOD. - GLOW PLUG 2 OR ELECTRONIC COLD START | |
| 3 | * | * | Not Used | |
| 4 | * | * | Not Used | |
| 5 | CE245 (VT-WH) | 4 | CTRL MOD. - GLOW PLUG 3 OR ELECTRONIC COLD START | |
| 6 | CE246 (YE-BU) | 4 | CTRL MOD. - GLOW PLUG 4 OR ELECTRONIC COLD START | |
| 7 | CE247 (GN-WH) | 4 | CTRL MOD. - GLOW PLUG 5 | |
| 8 | CE248 (WH-BN) | 4 | CTRL MOD. - GLOW PLUG 6 | |
| 9 | * | * | Not Used | |
| 10 | * | * | Not Used | |
| 11 | CE251 (BN-GN) | 4 | CTRL MOD. - GLOW PLUG 7 | |
| 12 | CE252 (GY) | 4 | CTRL MOD. - GLOW PLUG 8 |
| Available Pigtail Kits | |
| Pigtail Kit Part Number: WPT-1544 |
Service Part Number: Gauge: 16 Pin material: Silver Cavitites: 12 Vehicle Uses: Connector - Inline Lamp - Front Turn Lamp - Headlamp - High/Low Beam Mirror - Sideview/Heated Module - Battery Energy Control Module - Extended Power Module - Gear Shift Module - Glow Plug Module - Transmission Ranger Control Trailer Tow - Vehicle Side |
| Pigtail Kit Part Number WPT-1125 |
Service Part Number: AU2Z-14S411-AMA Gauge: 16 Pin material: Silver Cavities: 12 Vehicle Uses Connector - Inline Mirror - Sideview |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.