Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Normal Operation And Fault Conditions
2021 Ford Edge SE, 4WDSECTION Normal Operation And Fault Conditions
WARNING: This page is about a different car, the 2021 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the SECM monitors various inputs to detect if a fault is present.
SECM DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC is pre-set in a new SECM and clears automatically when the SECM is configured correctly. This DTC also sets due to incomplete or improper PMI procedures. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to incomplete or improper PMI procedures. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.