Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Normal Operation
The PSCM receives vehicle configuration information from the IPC and stores the information for later use. When the ignition is set to ON, the PSCM compares the ECU configuration stored in memory to the configuration message sent from the IPC. If the stored data does not match the received data, a DTC is set. This is most likely due to a new module not being programmed correctly or the programming was interrupted.
- CE1: CHECK THE IPC CONFIGURATION
- Review the vehicle repair history for recent service actions related to the IPC.
- Have there been any recent service actions with the IPC?
Yes No REPEAT the PMI procedure as directed by the diagnostic scan tool. REFER to the Instrumentation, Message Center and Warning Chimes article and DIAGNOSE any IPC concerns.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.