Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Trigger
This DTC sets after the PSCM experiences a momentary loss of vehicle voltage. Prior to shutting down, the PSCM stores data in memory, when the ignition is set to ON, the PSCM reads this data and if it is missing or corrupted, this DTC sets. Therefore, the presence of DTC U3001 means the loss of vehicle voltage occurred prior to the DTC being set. Consult the DTC Index for additional information if needed.
This DTC also sets if any of the charging system (i.e., battery, alternator, etc.) components, fuses, wiring or connections between the charging system and the PSCM are corroded, loose, damaged or disconnected.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.