SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 505 (ELECTRONIC POWER ASSIST STEERING (EPAS) GUIDED ROUTINE)DTC/SYMPTOM SELECTIONDTC INDEXPSCM - POWER STEERING CONTROL MODULEDTC U3000: CONTROL MODULEDIAGNOSTIC AIDS
2021 Ford Edge SE, 4WD

Diagnostic Aids

2021 Ford Edge SE, 4WDSECTION Diagnostic Aids
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2021 Lincoln Corsair, 2021 Lincoln Aviator, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, and 2021 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.

For DTC U3000:05, the PSCM removes steering assist, enters into manual mode and sends a message to the IPC to display POWER STEERING ASSIST FAULT in the message center.

For DTC U3000:46, initially the PSCM uses a default steering assist and may set DTC U2100:00. If DTC U3000:46 returns on the next ignition cycle, the PSCM disables steering assist, enters manual mode and sends a message to the instrument cluster to display POWER STEERING MALFUNCTION SERVICE NOW in the message center.

For DTC U3000:49, the PSCM removes steering assist, enters into manual mode and sends a message to the IPC to display POWER STEERING ASSIST FAULT in the message center.

For DTC U3000:61, the PSCM removes steering assist, enters into manual mode and transmits an invalid steering angle message over the HS-CAN. The module also sends a message to the IPC to display POWER STEERING ASSIST FAULT in the message center.

For DTC U3000:66, the IPC displays POWER STEERING MALFUNCTION SERVICE NOW in the message center when this DTC is set. DTC U3000:96 cannot be cleared using a diagnostic scan tool, to clear this DTC follow the pinpoint test instructions.

Failure Action
05 GO to PINPOINT TEST B. 
42 GO to PINPOINT TEST B. 
49 GO to PINPOINT TEST B. 
4B GO to PINPOINT TEST BE. 
61 GO to PINPOINT TEST B. 
66 GO to PINPOINT TEST B. 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.