Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 505 (ELECTRONIC POWER ASSIST STEERING (EPAS) GUIDED ROUTINE)DTC/SYMPTOM SELECTIONDTC INDEXPSCM - POWER STEERING CONTROL MODULEDTC U2300: CENTRAL CONFIGURATIONDESCRIPTION
2021 Ford Edge SE, 4WD
DTC U2300: Central Configuration: Description
2021 Ford Edge SE, 4WDSECTION Description
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2021 Lincoln Corsair, 2021 Lincoln Aviator, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, and 2021 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.
When a new EPAS column is installed, the PSCM must be configured with the vehicle information. Configuration is checked during initial PSCM power up (ignition ON) with the voltage supply to the PSCM greater than 10 volts.
- DTC U2300:55 (Central Configuration: Not Configured). This DTC is set if the tire circumference information does not match what is available (invalid) in the PSCM. This DTC sets if PSCM detects the vehicle data configuration or the component base data configuration is missing or incomplete.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.