Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 502 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (DIESEL))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSP24DA - PARTICULATE MATTER SENSOR EXHAUST SAMPLE ERROR BANK 1
2021 Ford Edge SE, 4WD
P24DA - Particulate Matter Sensor Exhaust Sample Error Bank 1
2021 Ford Edge SE, 4WDSECTION P24DA - Particulate Matter Sensor Exhaust Sample Error Bank 1
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2022 Ford F-550 Super Duty, 2022 Ford F-450 Super Duty, 2022 Ford F-350 Super Duty, 2022 Ford F-250 Super Duty, and 2021 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P24DA - PARTICULATE MATTER SENSOR EXHAUST SAMPLE ERROR BANK 1
| Description: This DTC sets when the particulate matter bank 1, sensor 1 (PM11) module detects a PM11 sensor sample error. | |||
Possible Causes:
|
|||
| Diagnostic Aids: Carry out a visual inspection of the PM11 sensor and protection tube. Make sure the sensor and protection tube are undamaged and clear of obstructions. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST RB . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.