Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Normal Operation and Fault Conditions
With the ignition ON, the GWM sends messages to the ABS module over the HS-CAN 2. If the ABS module does not receive these messages within a certain time frame (usually less than 1 second), the ABS module sets DTCs. This can be due to a GWM failure, a circuit failure on the HS-CAN or an excessive load on the network. For information on the messages sent to the ABS module by the GWM, refer to the Network Message Chart in Description and Operation of the Anti-Lock Brake System (ABS) and Stability Control article.
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0146:00 | Lost Communication With Gateway 'A': No Sub Type Information | This DTC sets in the ABS module if the parking aid data message from the GWM is missing for more than 5 seconds. |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.