Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Normal Operation and Fault Conditions
2021 Ford Edge SE, 4WDSECTION Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
When the ignition is set to RUN, the ABS module and the PCM share VIN information through the GWM over the HS-CAN1 and HS-CAN2.
PPT AF ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fautl Trigger Conditions |
|---|---|---|
| U3002:62 | Vehicle Identification Number: Signal Compare Failure | Sets when the VIN message sent by the PCM over the HS-CAN does not match the VIN stored in the ABS module. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.