Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U0423: Invalid Data Received from Instrument Panel Cluster Control Module: Action
This DTC sets in the ABS module if the traction control switch message from the IPC contains "invalid" instead of actual switch information. Using a diagnostic scan tool, RETRIEVE and REPAIR all non-network DTCs in the IPC. REFER to the Instrumentaion, Message Center and Warning Chimes article. If no IPC DTCs are present, the DTC may be caused by an intermittent concern. SET the ignition to OFF. DISCONNECT and INSPECT all IPC electrical connectors for corrosion, bent pins, pushed-out pins and spread terminals. REPAIR as necessary.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.