Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC C0051: Steering Wheel Position Sensor
2021 Ford Edge SE, 4WDSECTION DTC C0051: Steering Wheel Position Sensor
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
| Failure | Action |
|---|---|
| 23 | GO to PINPOINT TEST LA |
| 27 | GO to PINPOINT TEST LA |
| 86 | GO to PINPOINT TEST LA |
| 54 | GO to PINPOINT TEST LA |
| 62 | GO to PINPOINT TEST LA |
| 64 | GO to PINPOINT TEST LA |
| 29 | This DTC is for information only and sets in continuous memory when the ABS module detects the engine has auto-stopped with vehicle speed less than 10 km/h (6 mph). Low voltage is expected in this vehicle mode and the DTC is set to indicate the vehicle was in this state. Due to this low voltage, critical CAN signal monitoring has detected missing signals or faulty data. Using a diagnostic scan tool, CLEAR the DTC. CYCLE the ignition from ON to OFF and back to ON. CARRY OUT the ABS module self-test. RETRIEVE and DIAGNOSE all other ABS module DTCs. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.