Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Symptom Chart
2021 Ford Edge SE, 4WDSECTION Symptom Chart
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2019 Lincoln Navigator, 2019 Lincoln Nautilus, 2019 Lincoln MKZ, 2019 Lincoln MKT, and 2019 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
| Symptom Occurs During | Symptom | Category Number |
|---|---|---|
| Startup: | No start/Normal crank | 1 |
| Hard start/Long crank | 2 | |
| Stall after start | 3 | |
| Diesels/Runs on | 4 | |
| Idle: | MIL | 5 |
| Stalls/Quits | 6 | |
| Slow | 7 | |
| Slow return | 8 | |
| Rolling | 9 | |
| Fast | 10 | |
| Rough | 11 | |
| Misses | 12 | |
| Backfires | 13 | |
| Acceleration: | Stalls/Quits | 6 |
| Misses | 12 | |
| Bucks/Jerks | 14 | |
| Backfires | 13 | |
| Hesitation | 15 | |
| Lack/Loss of power | 16 | |
| Surge | 17 | |
| Spark knock | 18 | |
| Cooling system temperature | 19 | |
| Poor fuel economy | 20 | |
| Emissions compliance | 21 | |
| Cruise: | Stalls/Quits | 6 |
| Misses | 12 | |
| Bucks/Jerks | 14 | |
| Backfires | 13 | |
| Lack/Loss of power | 16 | |
| Surge | 17 | |
| Spark knock | 18 | |
| Cooling system temperature | 19 | |
| Poor fuel economy | 20 | |
| Emissions compliance | 21 | |
| Deceleration: | Stalls/Quits | 6 |
| Backfires | 13 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.