Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Selecting Parameter Identification (PID)
2021 Ford Edge SE, 4WDSECTION Selecting Parameter Identification (PID)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2019 Ford Transit-350 HD, 2019 Ford Transit-350, 2019 Ford Transit-250, 2019 Ford Transit-150, and 2019 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Connect the scan tool to the data link connector (DLC). Turn off all accessories. If the vehicle is equipped with a power take off (PTO) system or auxiliary idle control, it must be turned off to carry out the self-tests.
- Carry out the necessary vehicle preparation and visual inspection. Refer to QUICK TEST DESCRIPTION .
- Refer to the scan tool manufacturers manual for instructions.
- Follow the operating instructions from the menu.
- Access and select the PIDs to begin monitoring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.