Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Intake Air System (Transit)
2021 Ford Edge SE, 4WDSECTION Intake Air System (Transit)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2019 Ford Transit-350 HD, 2019 Ford Transit-350, 2019 Ford Transit-250, 2019 Ford Transit-150, and 2019 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Number | Description |
|---|---|---|
| 1 | - | Intake Air |
| 2 | - | Compressed Air |
| 3 | - | Exhaust Air |
| 4 | - | Air Filter |
| 5 | - | Mass Airflow/Intake Air Temperature (MAF/IAT) Sensor |
| 6 | - | Turbocharger Intake Compressor |
| 7 | - | Cylinder Head |
| 8 | - | Turbocharger Exhaust Turbine |
| 9 | - | Outlet To Exhaust System |
| 10 | - | Exhaust Manifold |
| 11 | - | Exhaust Gas Recirculation Temperature Bank 1, Sensor 1 (EGRT 11) |
| 12 | - | Exhaust Gas Recirculation (EGR) Cooler Bypass Valve |
| 13 | - | Exhaust Gas Recirculation (EGR) Cooler |
| 14 | - | Exhaust Gas Recirculation (EGR) Valve |
| 15 | - | Intake Manifold |
| 16 | - | Exhaust Gas Recirculation Temperature Bank 1, Sensor 2 (EGRT 12) |
| 17 | - | Manifold Absolute Pressure (MAP) Sensor |
| 18 | - | Intake Throttle Assembly |
| 19 | - | Charge Air Cooler Temperature (CACT) Sensor |
| 20 | - | Charge Air Cooler (CAC) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.