Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Tests W: Exhaust Gas Recirculation (EGR) System: Introduction
2021 Ford Edge SE, 4WDSECTION Introduction
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2019 Ford Transit-350 HD, 2019 Ford Transit-350, 2019 Ford Transit-250, 2019 Ford Transit-150, and 2019 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.
This pinpoint test is intended to diagnose the following:
- harness circuits: VREF, EGRVCH, EGRVCL, EGR and SIGRTN
- EGR valve (9D475)
- PCM (12A650)
Harness Side
| Circuit | Pin |
|---|---|
| VREF (Reference Voltage) | 5 |
| EGR (Exhaust Gas Recirculation) | 3 |
| EGRVCL (Exhaust Gas Recirculation Valve Control Low) | 6 |
| EGRVCH (Exhaust Gas Recirculation Valve Control High) | 2 |
| SIGRTN (Signal Return) | 1 |
Harness Side
| Circuit | Pin |
|---|---|
| EGR (Exhaust Gas Recirculation) | 61 |
| EGRVCL (Exhaust Gas Recirculation Valve Control Low) | 82 |
| EGRVCH (Exhaust Gas Recirculation Valve Control High) | 81 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.