SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 472 (ABS GUIDED ROUTINE)PINPOINT TESTSPINPOINT TESTS S: ABS MODULE COMMUNICATION CONCERN WITH TBMPOSSIBLE CAUSES
2021 Ford Edge SE, 4WD

Possible Causes

2021 Ford Edge SE, 4WDSECTION Possible Causes
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  • Network communication concern
  • Battery/charging system concern
  • TBM
  • ABS module
  1. S1: CHECK THE COMMUNICATION NETWORK 
    • Ignition ON, engine OFF.
    • Press the Read Vehicle Information button to view the results of the modules communicating on the network.
    • Retrieve the continuous memory DTCs.
    • Does the TBM pass the Network Test? 
    Yes No
    Go to  S2. DIAGNOSE the scan tool does not communicate with the TBM. REFER to the Module Communications Network article.
  2. S2: RECHECK FOR DTC U0137:00 AND U0137:87 

    Carry out the ABS self-test.

    • Clear the ABS DTCs.
    • Ignition OFF.
    • Ignition ON, engine OFF.

      Carry out the ABS self-test.

    • Is DTC U0137:00, U0137:87 retrieved again? 
    Yes No
    Go to  S3. The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  3. S3: CHECK FOR DTC U3003:16 AND U3003:17 
    • Review the results from the ABS module self-test.
    • Is DTC U3003:16 or U3003:17 present? 
    Yes No
    For DTC U3003:16, Go to PINPOINT TEST A .
    For DTC U3003:17, Go to PINPOINT TEST F .    		 Go to  S4.
  4. S4: CHECK FOR TBM DTCS 

    Carry out the TBC self-test.

    • Are any DTCs present? 
    Yes No
    DIAGNOSE the TBM DTC. REFER to the Auxiliary Brake System article. Go to  S5.
  5. S5: CHECK FOR DTC U0137:XX SET IN OTHER MODULES 
    • Ignition OFF.
    • Retrieve the continuous memory DTCs.
    • Is DTC U0137:XX set in any other module in addition to the ABS module? 
    Yes No
    INSTALL a new TBM.
    CHECK OASIS for any applicable Technical Service Bulletins TSBs.
    If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions.
    If no TSBs address this concern, INSTALL a new TBM. REFER to the Auxiliary Brake System article.    		 INSTALL a new ABS module.
    CHECK OASIS for any applicable Technical Service Bulletins TSBs.
    If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions.
    If no TSBs address this concern, INSTALL a new ABS module. REFER to the Anti-Lock Brake System (ABS) and Stability Control article.
    ORDER a replacement ABS module and INCLUDE the RVC on the form.
    If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.