SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 47 (REAR DISC BRAKE SYSTEM)REMOVAL AND INSTALLATIONREAR BRAKE DISCREMOVAL
2021 Ford Edge SE, 4WD

Rear Brake Disc: Removal

2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.

All vehicles 

  1. Remove the wheel and tire. Refer to: Wheel and Tire - Vehicles With: Single Rear Wheels . Refer to: Wheel and Tire - Vehicles With: Dual Rear Wheels .

    Vehicles with dual rear wheels (DRW) 

  2. NOTE: The brake disc is part of the wheel hub on dual rear wheel (DRW) applications.

    Remove the wheel bearing and wheel hub. Refer to: Wheel Hub - Full Floating Axle - Vehicles With: Dana M275/Dana M300.

    Vehicles with single rear wheels (SRW) 

  3. NOTE: Do not pry in the caliper sight hole to retract the pistons as this can damage the pistons and boots.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.