Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 460 (ROOF OPENING PANEL)GENERAL PROCEDURESROOF OPENING PANEL ALIGNMENT

2021 Ford Edge SE, 4WD

Roof Opening Panel Alignment

2021 Ford Edge SE, 4WDSECTION Roof Opening Panel Alignment

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

Adjustment

NOTE: The front sliding glass panel initialization procedure must be done when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel glass has been removed or adjusted, or if the roof opening panel frame has been removed.

Fully close the roof opening panel.

Courtesy of FORD MOTOR COMPANY
Measure the front and rear of the roof opening panel glass to roof clearances as shown.

Courtesy of FORD MOTOR COMPANY
If adjustment is needed, fully open the roof opening panel shield.

Courtesy of FORD MOTOR COMPANY
Remove the roof opening panel blinds. Refer to: Roof Opening Panel Blind .
Adjust the roof opening panel glass.
1. NOTE: LH side shown, RH side similar.
  
  On both sides, loosen the retainers to adjust the roof opening panel glass.
  
  Torque: 35 lb.in (4 Nm)
2. Adjust the roof opening panel glass as necessary.
Courtesy of FORD MOTOR COMPANY
Install the roof opening panel blinds. Refer to: Roof Opening Panel Blind .
If any adjustment was made, initialize the roof opening panel glass. Refer to: Power Roof Opening Panel Initialization .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.