Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test F : The One-Touch Open/Close Is Inoperative: Notes
Refer to Power Windows for schematic and connector information
Normal Operation and Fault Conditions
When the sunroof OPEN, CLOSE, or VENT switch is pressed and immediately released in less than 1 second (one touch operation) a signal is sent to the sunroof motor to operate the request on one touch mode. The sunroof must be in the fully closed position for the vent one touch mode to activate.
Possible Causes
- Roof opening panel initialization
- Roof opening panel control switch
- Roof opening panel motor/module assembly
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.