SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (HYDRAULIC BRAKE SYSTEM ACTUATION)GENERAL PROCEDURESADJUSTABLE PEDAL INDEXING
2021 Ford Edge SE, 4WD

Adjustable Pedal Indexing

2021 Ford Edge SE, 4WDSECTION Adjustable Pedal Indexing
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

NOTE: The adjustable pedal system must be indexed whenever the brake pedal assembly or accelerator pedal assembly is installed or damage to the components may result.
  1. Disconnect the adjustable pedal motor drive cable from the adjustable brake pedal drive.
    GFD200946Courtesy of FORD MOTOR COMPANY
  2. Operate the accelerator pedal to the full rearward position.
    GFD200947Courtesy of FORD MOTOR COMPANY
  3. Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
    GFD200948Courtesy of FORD MOTOR COMPANY
  4. Operate the adjustable pedals to the full forward position.
    GFD200949Courtesy of FORD MOTOR COMPANY
  5. Disconnect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
    GFD200946Courtesy of FORD MOTOR COMPANY
  6. Operate the adjustable accelerator pedal to the full forward position.
    GFD200950Courtesy of FORD MOTOR COMPANY
  7. Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.

    • Check that the brake and accelerator pedals can be fully adjusted forward and rearward.

GFD200948Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.