Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 459 (BODY CLOSURES)GENERAL PROCEDURESHOOD ALIGNMENT
2021 Ford Edge SE, 4WD
Hood Alignment
2021 Ford Edge SE, 4WDSECTION Hood Alignment
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
For information on Ford Color Coded Illustrations refer to OEM Color Coding .
Inspection
NOTE:
Removal steps in this procedure may contain installation details.
- Inspect the hood-to-body dimensions.
All alignments
- Remove the hood latch. Refer to: Hood Latch
.
Hood fore and aft, left and right alignments
- Loosen the nuts enough to permit movement of the hood and adjust as required.
- Tighten the nuts.
Torque: 18 lb.ft (25 Nm)
Hood front up and down alignments
- Adjust the bump stop rubbers.
- Adjust the hood as required.
All alignments
- Inspect the body-to-hood dimensions.
- Install the removed components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.