Pinpoint Test S : U3002:62: Notes

2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Normal Operation and Fault Conditions 

When the ignition is ON, the ABS module and the PCM share VIN information through the GWM over the HS-CAN1 and the HS-CAN2.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
U3002:62 Vehicle Identification Number: Signal Compare Failure This DTC sets in continuous memory if the VIN message sent by the PCM over the HS-CAN1 does not match the VIN stored in the ABS module.

Possible Causes 

  • Module configuration (ABS and PCM)
  • ABS module
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.