SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 45 (ANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROL)DIAGNOSIS AND TESTINGANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROLPINPOINT TESTSPINPOINT TEST A : U3003:16NOTES
2021 Ford Edge SE, 4WD

Pinpoint Test A : U3003:16: Notes

2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Vehicle Dynamic Systems for schematic and connector information.

Normal Operation and Fault Conditions 

The ABS module, hydraulic pump and solenoid valves require an operating voltage that is between 10 and 17 volts. The ABS module receives this voltage from the BJB. The ABS module has 2 ground circuits that splice together and terminate at a single location. Excessive resistance or an open in one or more of these circuits, a discharged battery or a inoperative charging system results in the ABS module setting a DTC.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
U3003:16 Battery Voltage: Circuit Voltage Below Threshold This DTC sets in continuous memory and on-demand if the voltage supplied to the ABS module falls below 10 volts.

Possible Causes 

  • Fuses
  • Wiring, terminals or connectors
  • Charging system concern
  • Battery
  • ABS module

Visual Inspection and Diagnostic Pre-checks 

  • Make sure both battery terminals and cables are free of any corrosion and other contaminants.
  • Make sure both battery terminals are tightened to their correct torque specifications.
  • Make sure BJB fuses 32 (5A), 52 (60A) and 59 (30A) are OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.