DTC Chart: Powertrain Control Module (PCM)

2021 Ford Edge SE, 4WDSECTION DTC Chart: Powertrain Control Module (PCM)
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .

PCM DTC Chart 

DTC Description Action
P193C Steering Wheel Angle Sensor This DTC sets if the information in the steering wheel angle sensor message is outside of the programmed set of parameters. This is most likely due to steering wheel angle sensor concerns, wiring harness concerns or vehicle communication concerns.
If the vehicle is equipped  with adaptive steering, using a diagnostic scan tool, CARRY OUT the SASM-clockspring self-test. DIAGNOSE any SASM-clockspring Diagnostic Trouble Codes (DTCs).
If the vehicle is not equipped  with adaptive steering or  if there are no Diagnostic Trouble Codes (DTCs) present in the SASM-clockspring, using a diagnostic scan tool, CARRY OUT the SCCM self-test. DIAGNOSE any SCCM Diagnostic Trouble Codes (DTCs).
If there are no Diagnostic Trouble Codes (DTCs) present in the SCCM, using a diagnostic scan tool, CARRY OUT the ABS module self-test. DIAGNOSE any ABS module Diagnostic Trouble Codes (DTCs).
P1501 Vehicle Speed Sensor Out of Self Test Range This DTC sets if the information in the wheel speed sensor message is outside of the programmed set of parameters. This is most likely due to wheel speed sensor concerns, wiring harness concerns, wheel speed sensor encoder concerns or vehicle communication concerns.
Using a diagnostic scan tool, CARRY OUT the ABS module self-test. DIAGNOSE any ABS module Diagnostic Trouble Codes (DTCs).
- All Other PCM Diagnostic Trouble Codes (DTCs) REFER to: Electronic Engine Controls - 6.2L V8 . Refer to: Electronic Engine Controls - 6.8L Triton-30V - V10 . Refer to: Electronic Engine Controls - 6.7L Power Stroke Diesel .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.