SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 442 (TRANSFER CASE)INSTALLATIONTRANSFER CASE
2021 Ford Edge SE, 4WD

Transfer Case

2021 Ford Edge SE, 4WDSECTION Transfer Case
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING .

  1. NOTE: The help of an assistant will be required.

    Position the transfer case on the crossmember. Lower the transmission approximately 25.4 mm (1 in).

    GFD464913Courtesy of FORD MOTOR COMPANY
  2. NOTE: The help of an assistant will be required.

    Position the transfer case to the transmission and onto the output shaft.

    GFD464914Courtesy of FORD MOTOR COMPANY
  3. NOTE: Do not reuse the old transfer case-to-transmission bolts.

    Install new transfer case-to-transmission bolts.

    Torque: 168 lb.in (19 Nm)

    GFD464915Courtesy of FORD MOTOR COMPANY
  4. Refer to: Transmission Support Insulator (6R80) . Refer to: Transmission Support Insulator (10R80) .
  5. Install the LH exhaust support bracket and bolt.

    Torque: 26 lb.ft (35 Nm)

    GFD464867Courtesy of FORD MOTOR COMPANY
  6. Install the transmission support crossmember. Refer to: Transmission Support Crossmember - 10-Speed Automatic Transmission - 10R80 .
  7. Connect the vent hose to the transfer case.
    GFD464866Courtesy of FORD MOTOR COMPANY
  8. Connect the shift motor electrical connector and attach the harness retainer clip to the transfer case.
    GFD464916Courtesy of FORD MOTOR COMPANY
  9. NOTE: Align the index marks made during removal.

    Install the rear driveshaft. Refer to: Rear Driveshaft .

  10. NOTE: Align the index marks made during removal.

    Install the front driveshaft. Refer to: Front Driveshaft .

  11. Check the transfer case fluid level. Refer to: Transfer Case Draining and Filling .
  12. If equipped. Position the skid plate and install the skid plate bolts.

    Torque: 30 lb.ft (40 Nm)

GFD464917Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.