Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Exploded View Of LH of Engine
2021 Ford Edge SE, 4WDSECTION Exploded View Of LH of Engine
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
LH View 1
| Item | Part Number | Description |
|---|---|---|
| 1 | 14C508 | Wiring harness-to-engine bracket |
| 2 | 9P995 | Fuel tube front support bracket |
| 3 | 9D477 | EGR valve-to-exhaust manifold tube assembly |
| 4 | 8A544 | Coolant inlet connector assembly |
| 5 | 9F459 | EGR EP (exhaust pressure) valve tube assembly |
| 6 | 6B667 | Oil level tube and indicator assembly |
| 7 | 6750 | Oil level indicator |
| 8 | 9P995 | Fuel tube front support bracket |
| 9 | 9Y438 | EGR coolant inlet tube assembly |
| 10 | 8D611 | LH FEAD (front end accessory drive) bracket |
LH View 2
| Item | Part Number | Description |
|---|---|---|
| 1 | 9448 | LH exhaust manifold gasket |
| 2 | 9431 | LH exhaust manifold |
| 3 | 6A051 | Engine block heater assembly |
| 4 | 9Y439 | EGR cooler outlet hose assembly |
| 5 | 9U438 | EGR cooler assembly |
| 6 | 9F465 | EGR cooler mounting bracket |
| 7 | 9F465 | EGR cooler mounting bracket |
| 8 | 9N454 | LH exhaust manifold heat shield |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.