Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Chart: SCCM
2021 Ford Edge SE, 4WDSECTION DTC Chart: SCCM
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B1007:09 | High-Beam Headlamp Switch: Component Failure | INSTALL a new LH steering column multifunction switch. Refer to: Steering Column Multifunction Switch LH . CLEAR the Diagnostic Trouble Codes (DTCs). Run the SCCM self-test. If the DTC returns, INSTALL a new SCCM. For vehicles without adaptive steering, REFER to: Steering Column Control Module (SCCM) . For vehicles with adaptive steering, REFER to: Steering Column Control Module (SCCM) - Vehicles With: Adaptive Steering . |
| B1D36:09 | Turn Indicator Switch: Component Failure | INSTALL a new LH steering column multifunction switch. Refer to: Steering Column Multifunction Switch LH . CLEAR the Diagnostic Trouble Codes (DTCs). Run the SCCM self-test. If the DTC returns, INSTALL a new SCCM. For vehicles without adaptive steering, REFER to: Steering Column Control Module (SCCM) . For vehicles with adaptive steering, REFER to: Steering Column Control Module (SCCM) - Vehicles With: Adaptive Steering . |
| All other SCCM Diagnostic Trouble Codes (DTCs) | - | REFER to: Steering Wheel and Column Electrical Components . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.