Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
BCM DTC Chart
2021 Ford Edge SE, 4WDSECTION BCM DTC Chart
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B10C7:01 | Interior Trunk Antenna: General Electrical Failure | GO to Pinpoint Test A |
| B10C8:01 | Interior Centre Antenna: General Electrical Failure | GO to Pinpoint Test A |
| B10D7:05 | PATS Key: System Programming Failure | DIAGNOSE all other Diagnostic Trouble codes (DTCs) first. If no other Diagnostic Trouble codes (DTCs) are present, PROGRAM the suspect passive key again. If key programming fails, REPLACE the suspect passive key. PROGRAM the new passive key. REFER to: Anti-Theft Key Programming - Scan Tool . |
| B10D7:55 | PATS Key: Not Configured | The Configurable Engine Immobilizer (CEI) was not completed during the PMI procedure. CARRY OUT the Configurable Engine Immobilizer (CEI) as part of the PMI procedure. |
| B10D8:00 | PATS Key Less Than Minimum Programmed: No Sub Type Information | Less than 2 keys are programmed (minimum of 2 keys must be programmed). PROGRAM the customer's second key. REFER to: Anti-Theft Key Programming - Scan Tool . |
| B10DA:51 | PATS Target Identifier: Not Programmed | There is no PCM ID stored in the BCM memory. PERFORM a parameter reset. REFER to: Anti-Theft Key Programming - Scan Tool . |
| B11C6:01 | Passenger Door External Antenna: General Electrical Failure | GO to Pinpoint Test A |
| B11CA:01 | Driver Door External Antenna: General Electrical Failure | GO to Pinpoint Test A |
| B1336:01 | Left Front Door External Antenna: General Electrical Failure | GO to Pinpoint Test A |
| B1337:01 | Right Front Door External Antenna: General Electrical Failure | GO to Pinpoint Test A |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to Body Control Module (BCM) : |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.