Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test D : The Windshield Wipers Stay On Continuously: Notes
Refer to Wipers and Washers appropriate service information
Normal Operation and Fault Conditions
REFER to: Wipers and Washers - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | Sets when the BCM detects a short to ground from the wiper relay control circuit. |
SCCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B1008:09 | Wiper Mode Switch: Component Failure | Sets when the SCCM detects a fault from the wiper/washer switch input. |
| B1131:02 | Wiper Motor Module: General Signal Failure | Sets when the input to the windshield wiper motor from the fail-safe circuit does not match the requested input from the SCCM. |
Possible Sources
- Wiring, terminals or connectors
- Wiper/washer switch
- Windshield wiper motor
- SCCM
- BCM
Visual Inspection and Diagnostic Pre-checks
- Inspect the wiper/washer switch for damage
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.