Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 371 (EXTERIOR LIGHTING (1 OF 2))
2021 Ford Edge SE, 4WD
Section 371 (Exterior Lighting (1 Of 2))
2021 Ford Edge SE, 4WDSECTION Section 371 (Exterior Lighting (1 Of 2))
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Exterior Lighting - Overview
- Exterior Lighting - System Operation and Component Description
- Diagnosis And Testing
- Autolamps
- Daytime Running Lamps (DRL)
- DTC Chart: Body Control Module (BCM)
- Symptom Chart: Daytime Running Lamps (DRL)
- Pinpoint Tests
- Pinpoint Test A : The DRL (Daytime Running Lamps) Are Inoperative - Led (Light Emitting Diode) Headlamps
- Pinpoint Test B : The DRL (Daytime Running Lamps) Are Always On - Led (Light Emitting Diode) Headlamps
- Pinpoint Test C : The DRL (Daytime Running Lamps) Are Inoperative Or Always On - Halogen Headlamps
- Fog Lamps
- DTC Chart: BCM
- Symptom Chart: Fog Lamps
- Pinpoint Tests
- Headlamps
- Exterior Lighting (1 Of 2)
- Symptom Chart: Headlamps
- Pinpoint Tests
- Pinpoint Test A : One Or Both Low Beams Is Inoperative - Halogen Or Led (Light Emitting Diode) Headlamps
- Pinpoint Test B : One Or Both Low Beams Is Inoperative - High Intensity Discharge (Hid) Headlamps, China Vehicles Only
- Pinpoint Test C : One Or Both High Beams Is Inoperative
- Pinpoint Test D : One Or Both Low Beams Are On Continuously - Halogen Or Led (Light Emitting Diode) Headlamps
- Pinpoint Test E : One Or Both Low Beams Are On Continuously - High Intensity Discharge (Hid) Headlamps
- Pinpoint Test F : One Or Both High Beams Are On Continuously
- Pinpoint Test G : The Flash-To-Pass Feature Is Inoperative
- Pinpoint Test H : The Automatic High Beam Feature Is Inoperative
- Pinpoint Test I : The Manual Headlamp Leveling Is Inoperative/Does Not Operate Correctly - Except North AMERICA
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.