Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 370 (STEERING COLUMN)DIAGNOSIS AND TESTINGSTEERING COLUMNPINPOINT TESTSPINPOINT TEST C : THE ADJUSTABLE STEERING COLUMN OPERATES IN ONE SECOND INTERVALS WHEN USING THE STEERING COLUMN CONTROL SWITCH (JOG MODE)NOTES
2021 Ford Edge SE, 4WD
Pinpoint Test C : The Adjustable Steering Column Operates In One Second Intervals When Using The Steering Column Control Switch (Jog Mode): Notes
2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Adjustable Steering Column for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Steering Column - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B12A7:11 | Steering Column Tilt Sensor A: Circuit Short To Ground | This DTC sets in continuous memory and on-demand if the DSM detects a short to battery voltage on the telescopic sensor feedback circuit. |
| B12A7:12 | Steering Column Tilt Sensor A: Circuit Short To Battery | This DTC sets in continuous memory and on-demand if the DSM detects a short to ground on the telescopic sensor feedback circuit. |
| B12A8:11 | Steering Column Telescope Sensor A: Circuit Short To Ground | This DTC sets in continuous memory and on-demand if the DSM detects a short to battery voltage on the tilt sensor feedback circuit. |
| B12A8:12 | Steering Column Telescope Sensor A: Circuit Short To Battery | This DTC sets in continuous memory and on-demand if the DSM detects a short to ground on the tilt sensor feedback circuit. |
| B1375:31 | Steering Column Tilt Motor: No Signal | This DTC sets when the DSM senses the tilt motor circuit current draw is above a specified threshold when the driver is active. |
| B137E:31 | Steering Column Telescope Motor: No Signal | This DTC sets when the DSM senses the telescope motor circuit current draw is above a specified threshold when the driver is active. |
Possible Sources
- Wiring, terminals or connectors
- Adjustable steering column tilt motor sensor (serviced with tilt motor)
- Adjustable steering column telescopic motor sensor (serviced with steering column)
- DSM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.