Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Rear Cover: Installation
2021 Ford Edge SE, 4WDSECTION Installation
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new engine rear cover gasket.
-
NOTE: To prevent engine damage, replace damaged or missing dowel pins before installing the engine rear cover.
Install the engine rear cover and the bolts.
Torque:
Tighten bolts 1 through 9 to : 89 lb.in (10 Nm)
Tighten bolt 10 to : 35 lb.ft (48 Nm)
-
NOTE: Do not use magnetic screwdrivers or other magnetic tools around the CKP sensor and the crankshaft sensor pulse ring or damage to the components may occur.
Connect the CKP sensor electrical connector.
- Install the turbocharger downpipe bracket bolt.
Torque: 18 lb.ft (25 Nm)
- Refer to: Crankshaft Rear Seal .
- Refer to: Upper Oil Pan .
- Install the upper oil level indicator and tube. Refer to: Oil Level Indicator and Tube .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.