Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Trailer Brake Control Module (TBM): Removal
2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The trailer brake system is normally installed at the assembly plant, however, the system can be installed at the dealership. If the system is installed at the dealership, the TBM will be installed in place of the coin bin/storage tray and the IPC must be configured to communicate with the TBM. Refer to appropriate service information.
All vehicles
- Remove the FCIM. Vehicles Without: SYNC, Refer to: Front Controls Interface Module (FCIM)
.
Vehicles With: SYNC Without Touchscreen, Refer to: Front Controls Interface Module (FCIM)
.
Vehicles With: Touchscreen Display, Refer to: Front Controls Interface Module (FCIM)
.
Vehicles With: Bang and Olufsen Audio System, Refer to: Front Controls Interface Module (FCIM)
.
Vehicles equipped with floor console
- Remove the screws and the center instrument panel lower finish panel.
Vehicles without floor console
- Remove the screw, detach the clips and remove the center instrument panel lower finish panel.
- Detach the clips, disconnect the electrical connector(s) if equipped and remove the LH center instrument panel finish panel. Use the General Equipment: Interior Trim Remover
Vehicles equipped with floor console
- Place the transmission selector lever in the NEUTRAL position.
- Detach the clips and remove the floor console upper finish panel.
- Detach the clips, disconnect the electrical connector(s) (if equipped) and remove the LH center instrument panel finish panel. Use the General Equipment: Interior Trim Remover
All vehicles
-
NOTE: Do not pry on the face of the TBM or damage to the TBM may occur.
Pushing from the backside of the TBM, detach the module from the instrument panel.
- Disconnect the electrical connector and remove the TBM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.