Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test F : U0199: Notes
2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
DTC Fault Trigger Condition-PCM
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0199 | Lost Communication With "Door Control Module A" | The PCM sets this DTC if data messages from the DDM through the GWM are missing. |
Normal Operation and Fault Conditions
REFER to: Communications Network - System Operation and Component Description .
Possible Sources
- Communications network concern
- DDM
- GWM
- PCM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.