Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test Q : U0253:87: Notes
Refer to Module Communications Network for schematic and connector information.
Normal Operation and Fault Conditions
The BCM communicates with the IPMA through the GWM. REFER to: Communications Network .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0253:87 | Lost Communication With Accessory Protocol Interface Module: Missing Message | A continuous memory DTC that sets in the BCM if messages received from the APIM through the GWM are missing. |
Possible Sources
- Communication network concern
- Battery voltage concern
- GWM concern
- APIM
- BCM
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.