Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Snow Plow Package
The optional snowplow package adds a switch to the instrument panel and blunt cut for customer access. When the snowplow switch is enabled, a ground signal is received by the FCIM from the snowplow switch. The FCIM sends a message to the BCM which then grounds the rear heated seats/customer access relay control circuit. When the relay is energized, power is diverted from the rear heated seats and applied to the customer access blunt cut. When the snowplow switch is active, the following systems are disabled:
- AC inverter
- Fog lamps
- Heated steering wheel
- Heated seats
- Massaging seats
For more information on the snowplow package, refer to the Owner's Literature.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.