SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 261 (FUEL CHARGING AND CONTROLS - 6.7L POWER STROKE DIESEL)REMOVAL AND INSTALLATIONFUEL PUMP DRIVER MODULE (FPDM)REMOVAL
2021 Ford Edge SE, 4WD

Fuel Pump Driver Module (FPDM): Removal

2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, 2019 Ford F-250 Super Duty, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: JACKING AND LIFTING - OVERVIEW (2018)Jacking and Lifting - Overview (2019) .

    Pickup 

    NOTE: The fuel pump driver module (FPDM) is attached to the top of the frame rear crossmember.
  2. Disconnect the fuel pump driver module (FPDM) electrical connector.
    GFD407722Courtesy of FORD MOTOR COMPANY
  3. Remove the fuel pump driver module (FPDM) retainers and then remove the fuel pump driver module (FPDM).
    GFD407723Courtesy of FORD MOTOR COMPANY

    Chassis Cab 

    NOTE: The fuel pump driver module (FPDM) is attached to the front of the frame rear crossmember.
  4. Disconnect the fuel pump driver module (FPDM) electrical connector.
    GFD407724Courtesy of FORD MOTOR COMPANY
  5. Remove the fuel pump driver module (FPDM) retainers and then remove the fuel pump driver module (FPDM).
GFD407725Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.