Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
BCM DTC Chart
2021 Ford Edge SE, 4WDSECTION BCM DTC Chart
WARNING: This page is about a different car, the 2019 Ford F-350 Super Duty and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Description | Action |
|---|---|---|
| C113A:11 | Wakeup Control: Circuit Short To Ground | Without push-button start, REFER to: Passive Anti-Theft System (PATS) . With push-button start, GO to Pinpoint Test D |
| C113A:15 | Wakeup Control: Circuit Short To Battery or Open | Without push-button start, REFER to: Passive Anti-Theft System (PATS) . With push-button start, GO to Pinpoint Test D |
| P0830:11 | Clutch Pedal Switch "A" Circuit: Circuit Short To Ground | For vehicles without push button start, GO to Pinpoint Test A For vehicles with push button start, GO to Pinpoint Test B |
| U1000:00 | Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information | The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). REFER to: Body Control Module (BCM) . The BCM cannot enable the output until the cause of the short is corrected. REFER to: Body Control Module (BCM) . ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. |
| All Other DTCs | -- | REFER to: Body Control Module (BCM) . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.