Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 244 (ENGINE - 6.2L V8)REMOVAL AND INSTALLATIONVALVE COVER RHINSTALLATION

2021 Ford Edge SE, 4WD

Valve Cover RH: Installation

2021 Ford Edge SE, 4WDSECTION Installation

WARNING: This page is about a different car, the 2019 Ford F-350 Super Duty and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Installation of new seals is only required if damaged seals were removed.

Using the special tools, install a new VCT oil control solenoid seal. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 205-142 (T80T-4000-J) Installer, Differential Bearing Cone.

Courtesy of FORD MOTOR COMPANY
Install the oil fill cap.

Courtesy of FORD MOTOR COMPANY
Install a new RH valve cover gasket.

Courtesy of FORD MOTOR COMPANY
NOTE: If the valve cover is not installed and the fasteners tightened within 4 minutes, the sealant must be removed and the sealing area cleaned.

Apply an 8 mm (0.31 in) drop of Motorcraft® High Performance Engine RTV Silicone to the engine front cover-to-cylinder head joints.

Material: Motorcraft® High Performance Engine RTV Silicone / TA-357 (WSE-M4G323-A6)

Courtesy of FORD MOTOR COMPANY
Install the RH valve cover and tighten the bolts.
Torque: 89 lb.in (10 Nm)

Fig 1: RH Valve Cover Bolts Tightening Sequence
Courtesy of FORD MOTOR COMPANY
Position the wiring harness and connect the retainers and electrical connector.

Courtesy of FORD MOTOR COMPANY
Position the wiring harness and connect the retainers and electrical connectors.

Courtesy of FORD MOTOR COMPANY
- Connect the RH ignition wire retainers to the valve cover.
- Connect the RH ignition wires to the RH ignition coil-on-plugs.
Courtesy of FORD MOTOR COMPANY
Install the PCV tube and attach the retainer.

Courtesy of FORD MOTOR COMPANY
- Position the oil level indicator and install the bolt.
  Torque: 89 lb.in (10 Nm)
- If equipped with and automatic transmission, position the transmission fluid level indicator and install the bolt.
  Torque: 89 lb.in (10 Nm)
Courtesy of FORD MOTOR COMPANY
Remove the following items:
1. Install the air cleaner. Refer to: Air Cleaner .
2. Install the air cleaner outlet tube. Refer to: Air Cleaner Outlet Pipe .