Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 240 (WIPERS AND WASHERS)
2021 Ford Edge SE, 4WD
Section 240 (Wipers And Washers)
2021 Ford Edge SE, 4WDSECTION Section 240 (Wipers And Washers)
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Wipers and Washers
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Notes
- BCM DTC Fault Trigger Conditions
- SCCM DTC Fault Trigger Conditions
- Pinpoint Test A : All Windshield Wiper Modes Are Inoperative
- Pinpoint Test B : The Intermittent And/Or Low Speed Windshield Wipers Are Inoperative
- Pinpoint Test C : The High Speed Windshield Wipers Are Inoperative
- Pinpoint Test D : The Windshield Wipers Stay On Continuously
- Pinpoint Test E : The Windshield Wipers Do Not Operate Correctly In The Intermittent Mode
- Pinpoint Test F : The Rain Sensitive Wiper Feature Is Inoperative/Does Not Operate Correctly
- Pinpoint Test G : The Windshield Wipers Do Not Park At The Correct Position
- Pinpoint Test H : The Windshield Washer Is Inoperative
- Pinpoint Test I : The Windshield Washer Is Always On
- Pinpoint Test J : The Front Camera Washer Is Inoperative
- Wipers and Washers
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.