Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test C : The Adjustable Steering Column Operates In One Second Intervals When Using The Steering Column Control Switch (Jog Mode): Notes
The Adjustable Steering Column Operates In One Second Intervals When Using The Steering Column Control Switch (Jog Mode)
Refer to Adjustable Steering Column for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Steering Column - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B2330 | Column Reach Feedback Potentiometer Circuit Short to Battery | This DTC sets in continuous memory and on-demand if the DSM detects a short to battery voltage on the telescopic sensor feedback circuit. |
| B2331 | Column Reach Feedback Potentiometer Circuit Short to Ground | This DTC sets in continuous memory and on-demand if the DSM detects a short to ground on the telescopic sensor feedback circuit. |
| B2334 | Column Tilt Feedback Potentiometer Circuit Short to Battery | This DTC sets in continuous memory and on-demand if the DSM detects a short to battery voltage on the tilt sensor feedback circuit. |
| B2335 | Column Tilt Feedback Potentiometer Circuit Short to Ground | This DTC sets in continuous memory and on-demand if the DSM detects a short to ground on the tilt sensor feedback circuit. |
Possible Sources
- Wiring, terminals or connectors
- Adjustable steering column tilt motor sensor (serviced with tilt motor)
- Adjustable steering column telescopic motor sensor (serviced with telescopic motor)
- DSM
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.