Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 237 (STEERING COLUMN)DESCRIPTION AND OPERATIONSTEERING COLUMN - SYSTEM OPERATION AND COMPONENT DESCRIPTIONNETWORK MESSAGE CHART - POWER ADJUSTABLE STEERING COLUMN
2021 Ford Edge SE, 4WD
Network Message Chart - Power Adjustable Steering Column
2021 Ford Edge SE, 4WDSECTION Network Message Chart - Power Adjustable Steering Column
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Module Network Input Messages
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Ignition status | BCM | This message is used to communicate ignition status, which is used for initiating the easy entry/easy exit feature. |
| Personality recall | BCM | When the personality recall command is received from the BCM, the DSM stores or recalls the steering wheel position. If a RKE transmitter has been programmed to a memory position, this input is used to recall the steering column position. |
| Steering column position switch status | SCCM | Message to control the adjustable steering column when the steering column control switch is pressed. The message is transmitted from the SCCM to the DSM via the GWM. |
| Memory switch status | DDM | When the memory set switch (1, 2 or 3) is activated, the DDM sends this message to the DSM which then stores or recalls the corresponding memory seat position. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.