Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 221 (TRANSFER CASE)REMOVAL AND INSTALLATIONTRANSFER CASE SHIFT LEVERREMOVAL

2021 Ford Edge SE, 4WD

Transfer Case Shift Lever: Removal

2021 Ford Edge SE, 4WDSECTION Removal

WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM Color Coding

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
Position the transfer case shift lever in neutral.

Courtesy of FORD MOTOR COMPANY
Remove the transfer case shift lever knob.

Courtesy of FORD MOTOR COMPANY
Remove the shift lever trim and boot.
- Release the shift lever trim clips.
- Remove the shift lever trim and boot.
Courtesy of FORD MOTOR COMPANY
Remove the shift lever bolts.
Torque: 62 lb.in (7 Nm)

Courtesy of FORD MOTOR COMPANY
- Disconnect the shift lever cable.
- Release the lock and position aside the shift lever cable.
Courtesy of FORD MOTOR COMPANY
Remove the shift lever assembly.

Courtesy of FORD MOTOR COMPANY

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.