Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transfer Case - Vehicles With: Electronic Shift Transfer Case: Notes
2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
For information on Ford Color Coded Illustrations refer to OEM Color Coding
Special Tool(s) / General Equipment
| 205-1018 Installation Tube | |
|---|---|
| 205-153 (T80T-4000-W) Handle | |
| 307-318 Remover, Stator Bearing TKIT-1994-FMH/FLMH TKIT-1994-LMH/MH TKIT-1994-FH | |
| 307-344 (T95P-7H150-A) Installer, Driven Sprocket Wheel TKIT-1995-F TKIT-1995-FM/FLM TKIT-1995-LM/M | |
| 307-549 Installer, Shift Shaft Fluid Seal TKIT-2005D1-F1 | |
| 307-626 Installer, Differential Seal TKIT-2008ET-FLM TKIT-2008ET-ROW | |
| 308-047 (T77F-1102-A) Remover, Bearing Cup | |
| 308-410 Installer, Output Shaft Front Bearing TKIT-1999-F/FLM/LT | |
| 308-943 Installer, Input Seal | |
| 308-944 Installer, Front Output Seal | |
| Slide Hammer | |
| Adjustable Mounting Arm | |
| Punch | |
| Copper Hammer |
Materials
| Name | Specification |
|---|---|
| Motorcraft® Ultra Silicone Sealant TA-29 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.