Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 211 (FRONT SUSPENSION - RWD)REMOVAL AND INSTALLATIONTRACK BAR BUSHINGINSTALLATION
2021 Ford Edge SE, 4WD
Track Bar Bushing: Installation
2021 Ford Edge SE, 4WDSECTION Installation
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Bushing should be centered in track bar with equal amounts of the bushing exposed on both sides of the track bar.
Install the new track bar bushing into the track bar. Use Special Service Tool: 204-608 Bushing Remover., 205-488 Installer, Drive Pinion Bearing., 205-090 (T75L-1165-B) Plate, Bearing/Oil Seal. Use the General Equipment: Hydraulic Press
- Install the track bar. Refer to: Track Bar . Refer to: Track Bar - Vehicles With: Integral Ball Joint .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.