SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 190 (FRONT DRIVE AXLE/DIFFERENTIAL)SPECIFICATIONSGENERAL SPECIFICATIONS
2021 Ford Edge SE, 4WD

General Specifications

2021 Ford Edge SE, 4WDSECTION General Specifications
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Item  Specification 
Backlash Specifications 
Backlash between ring gear and pinion 0.13-0.20 mm (0.005-0.008 in)
Maximum ring gear backlash variation 0.05 mm (0.002 in)
Rotational Torque Ranges 
Pinion bearing torque preload (1) 1.9-3.6 Nm (16-32 lb-in)
(1) Refer to the procedures in this information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.