SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 167 (FRONT SEATS (2 OF 2))REMOVAL AND INSTALLATIONFRONT SEATREMOVAL
2021 Ford Edge SE, 4WD

Front Seat: Removal

2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Driver seat shown, passenger seat similar.
  1. Position the seat to access the front seat bolts.

    • If a power seat cannot be positioned horizontally to access the front seat bolts, diagnose the inoperative horizontal seat track motor. Refer to: Front Seats .

    GFD410850Courtesy of FORD MOTOR COMPANY
  2. Depower the SRS. Refer to: Supplemental Restraint System (SRS) Depowering .
  3. Disconnect the seat harness electrical connector(s).

    1. Detach the wiring harness from the pin-type retainer.
    2. Release the locking tab(s) and rotate the position assurance lever(s).

    GFD410851Courtesy of FORD MOTOR COMPANY
  4. Remove the front seat bolt caps.
    GFD410852Courtesy of FORD MOTOR COMPANY
  5. NOTE: Follow the unique instructions or graphics for this step in the installation.

    Remove the front seat.

    • Remove and discard the front seat bolts.

GFD410853Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.